Advice and application
The application of Borellith is very straightforward to execute under your own management. Clearing the area for treatment is not necessary.
Borellith can be applied to existing surfaces and new concrete.
Pre-treatment
The substrate must be clean, dry and free of grease and oil.
It is important that the concrete surface is cleaned as thoroughly as possible in existing situations. The preferred treatment for vertical applications with contamination and lime blooming is to lightly sand the surface with a suitable wall sanding device.
Preferred treatment for contaminated floors is chemical cleansing with a scrub-suction machine / 1 disc machine.
Application
Borellith is easy to apply yourself using a low pressure spray (curing) device, with a (microfiber) roller and or paint brush.
Apply a single coat for a good seal.
You can also apply a 2nd (colour) layer to achieve a more intense colour if you wish.
It is important that there are no puddles on the surface during application.
Roll out any puddles.
Always apply from the bottom up for vertical applications; this helps to prevent stripe formation on the surface.
Properly protect glass and zinc.
The treated concrete surface can be re-commissioned with caution following the drying process.
Service
- clear and comprehensive instructions for use
- we will be pleased to advise you if you have any doubts
- Borèl also has special equipment available for you to hire